Bookmark this page:
- New-PocketGPSworld-POIs--Garmin-i3--CAUTION
- 12-24-2006
If you were Registered and logged in, you could reply and use other advanced thread options
I think I have just crashed (KILLED) my i3......
I downloaded and installed a new set of POIs from pocketgpsworld.co.uk (a
source I have used many times before without a problem) and now my i3
refuses to work. It is no longer found by POI Loader or Webupdater (latest
versions) and I cannot get past the opening selection screen. Choosing
"Where to?" takes me to the next screen but nothing happens when a selection
is made. If choosing "View map" or "Settings", nothing happens at all. I
have done a full reset and checked the diagnostics (but don't really know
what I'm looking at!). However, the diagnostics report that I am getting a
good satellite lock.
These are some of my other diagnostic results:-
RAM, SOM & ASIC = all Pass
Mem stats: 2435, 13, 396, 22.
There is no NAND result (should three be?)
It only switches off very slowly or if the batteries are taken out. Any help
very much appreciated .....
Watch for the SPAMTRAP.
> is made. If choosing "View map" or "Settings", nothing happens at all. I
> have done a full reset and checked the diagnostics (but don't really know
> what I'm looking at!). However, the diagnostics report that I am getting a
> good satellite lock.
> These are some of my other diagnostic results:-
> RAM, SOM & ASIC = all Pass
> Mem stats: 2435, 13, 396, 22.
> There is no NAND result (should three be?)
> It only switches off very slowly or if the batteries are taken out. Any
help
> have done a full reset and checked the diagnostics (but don't really know
> what I'm looking at!). However, the diagnostics report that I am getting a
> good satellite lock.
> These are some of my other diagnostic results:-
> RAM, SOM & ASIC = all Pass
> Mem stats: 2435, 13, 396, 22.
> There is no NAND result (should three be?)
> It only switches off very slowly or if the batteries are taken out. Any
> very much appreciated .....
> Watch for the SPAMTRAP.
I don't know the device, however, many devices have unknown access
> Watch for the SPAMTRAP.
features these days. Usually it's a case of button pressing/holding whilst
switching the device on.
It's also worthwhile switching and/or trying the same type of key
pressing/holding with the device connected to the PC with the access
software detecting a connection.
I brought a dead PDA back into action using similar methods.
Hiyer
I'll give that a try in a bit, however I'm not too hopeful. Take a look at
this Forum Thread which I started - it seems at least one other person has a
similar problem - this time with a Garmin Nuvi...
http://www.pocketgpsworld.com/modules.php?name=Forums&file=viewtopic&t=50203&start=45
Cheers.
Colin.
--
Watch for the SPAMTRAP.
>> I think I have just crashed (KILLED) my i3......
>> I downloaded and installed a new set of POIs from pocketgpsworld.co.uk (a
>> source I have used many times before without a problem) and now my i3
>> refuses to work. It is no longer found by POI Loader or Webupdater
>> (latest
>> versions) and I cannot get past the opening selection screen. Choosing
>> "Where to?" takes me to the next screen but nothing happens when a
>> I downloaded and installed a new set of POIs from pocketgpsworld.co.uk (a
>> source I have used many times before without a problem) and now my i3
>> refuses to work. It is no longer found by POI Loader or Webupdater
>> (latest
>> versions) and I cannot get past the opening selection screen. Choosing
>> "Where to?" takes me to the next screen but nothing happens when a
> selection
>> is made. If choosing "View map" or "Settings", nothing happens at all. I
>> have done a full reset and checked the diagnostics (but don't really know
>> what I'm looking at!). However, the diagnostics report that I am getting
>> a
>> good satellite lock.
>> These are some of my other diagnostic results:-
>> RAM, SOM & ASIC = all Pass
>> Mem stats: 2435, 13, 396, 22.
>> There is no NAND result (should three be?)
>> It only switches off very slowly or if the batteries are taken out. Any
>> have done a full reset and checked the diagnostics (but don't really know
>> what I'm looking at!). However, the diagnostics report that I am getting
>> a
>> good satellite lock.
>> These are some of my other diagnostic results:-
>> RAM, SOM & ASIC = all Pass
>> Mem stats: 2435, 13, 396, 22.
>> There is no NAND result (should three be?)
>> It only switches off very slowly or if the batteries are taken out. Any
> help
>> very much appreciated .....
>> Watch for the SPAMTRAP.
>> Watch for the SPAMTRAP.
> I don't know the device, however, many devices have unknown access
> features these days. Usually it's a case of button pressing/holding whilst
> switching the device on.
> It's also worthwhile switching and/or trying the same type of key
> pressing/holding with the device connected to the PC with the access
> software detecting a connection.
> I brought a dead PDA back into action using similar methods.
>
> features these days. Usually it's a case of button pressing/holding whilst
> switching the device on.
> It's also worthwhile switching and/or trying the same type of key
> pressing/holding with the device connected to the PC with the access
> software detecting a connection.
> I brought a dead PDA back into action using similar methods.
>
Eventually fixed using info from this thread but what a pain ....
http://www.pocketgpsworld.com/modules.php?name=Forums&file=viewtopic&t=50203&postdays=0&postorder=asc&start=45
Regards.
Colin.
--
Watch for the SPAMTRAP.
> Hiyer
> I'll give that a try in a bit, however I'm not too hopeful. Take a look at
> this Forum Thread which I started - it seems at least one other person has
> a similar problem - this time with a Garmin Nuvi...
>
http://www.pocketgpsworld.com/modules.php?name=Forums&file=viewtopic&t=50203&start=45
> I'll give that a try in a bit, however I'm not too hopeful. Take a look at
> this Forum Thread which I started - it seems at least one other person has
> a similar problem - this time with a Garmin Nuvi...
>
> Cheers.
> Colin.
> --
> Watch for the SPAMTRAP.
> Colin.
> --
> Watch for the SPAMTRAP.
>>> I think I have just crashed (KILLED) my i3......
>>> I downloaded and installed a new set of POIs from pocketgpsworld.co.uk
>>> (a
>>> source I have used many times before without a problem) and now my i3
>>> refuses to work. It is no longer found by POI Loader or Webupdater
>>> (latest
>>> versions) and I cannot get past the opening selection screen. Choosing
>>> "Where to?" takes me to the next screen but nothing happens when a
>>> I downloaded and installed a new set of POIs from pocketgpsworld.co.uk
>>> (a
>>> source I have used many times before without a problem) and now my i3
>>> refuses to work. It is no longer found by POI Loader or Webupdater
>>> (latest
>>> versions) and I cannot get past the opening selection screen. Choosing
>>> "Where to?" takes me to the next screen but nothing happens when a
>> selection
>>> is made. If choosing "View map" or "Settings", nothing happens at all.
>>> I
>>> have done a full reset and checked the diagnostics (but don't really
>>> know
>>> what I'm looking at!). However, the diagnostics report that I am getting
>>> a
>>> good satellite lock.
>>> These are some of my other diagnostic results:-
>>> RAM, SOM & ASIC = all Pass
>>> Mem stats: 2435, 13, 396, 22.
>>> There is no NAND result (should three be?)
>>> It only switches off very slowly or if the batteries are taken out. Any
>>> I
>>> have done a full reset and checked the diagnostics (but don't really
>>> know
>>> what I'm looking at!). However, the diagnostics report that I am getting
>>> a
>>> good satellite lock.
>>> These are some of my other diagnostic results:-
>>> RAM, SOM & ASIC = all Pass
>>> Mem stats: 2435, 13, 396, 22.
>>> There is no NAND result (should three be?)
>>> It only switches off very slowly or if the batteries are taken out. Any
>> help
>>> very much appreciated .....
>>> Watch for the SPAMTRAP.
>>> Watch for the SPAMTRAP.
>> I don't know the device, however, many devices have unknown access
>> features these days. Usually it's a case of button pressing/holding
>> whilst
>> switching the device on.
>> It's also worthwhile switching and/or trying the same type of key
>> pressing/holding with the device connected to the PC with the access
>> software detecting a connection.
>> I brought a dead PDA back into action using similar methods.
>> features these days. Usually it's a case of button pressing/holding
>> whilst
>> switching the device on.
>> It's also worthwhile switching and/or trying the same type of key
>> pressing/holding with the device connected to the PC with the access
>> software detecting a connection.
>> I brought a dead PDA back into action using similar methods.
>
Glad to hear you've fixed the problem.
- Garmin Keygen version 1.3 by JetMouse
- Garmin GPS
- 2008-01-03
- Multi stops along route
- Garmin GPS
- 2008-05-07
- toppo maps used on Garmin 60cs
- UK GPS Discussions
- 2006-04-09
- Garmin registration help
- Garmin GPS
- 2007-01-14
- Garmin POI loader problem
- Garmin GPS
- 2006-07-12
- Garmin City Select.
- Garmin GPS
- 2005-10-11
- Garmin Support
- Garmin GPS
- 2005-09-25
> I downloaded and installed a new set of POIs from pocketgpsworld.co.uk (a
> source I have used many times before without a problem) and now my i3
> refuses to work. It is no longer found by POI Loader or Webupdater (latest
> versions) and I cannot get past the opening selection screen. Choosing
> "Where to?" takes me to the next screen but nothing happens when a