Bookmark this page:
- TomTom-receiver-RJ11-pinout-
- 01-07-2012
If you were Registered and logged in, you could reply and use other advanced thread options
A friend has asked me to repair an old iPaq based Tomtom setup. The receiver
connects to the iPaq cradle using an RJ11 plug with 4 wires.
When I got the equipment there were only 3 wires connecting in the RJ11 (red,
brown and yellow) also the cable shield was loose and not connected.
Looking inside the receiver I see 4 wires (red, brown, yellow plus black) but
the black wire does not seem to appear in the cable.
So, simple question, what should be in the RJ11 - I will be replacing it? I'll
put red, brown and yellow back as per the original, but should the shield go in
the missing hole?
connects to the iPaq cradle using an RJ11 plug with 4 wires.
When I got the equipment there were only 3 wires connecting in the RJ11 (red,
brown and yellow) also the cable shield was loose and not connected.
Looking inside the receiver I see 4 wires (red, brown, yellow plus black) but
the black wire does not seem to appear in the cable.
So, simple question, what should be in the RJ11 - I will be replacing it? I'll
put red, brown and yellow back as per the original, but should the shield go in
the missing hole?
- Tomtom Wired Spec
- Satellite Navigation
- 2006-02-14
- TomTom GPSs are GARBAGE
- Tomtom GPS
- 2010-04-19
- TomTom 910 remote control
- Tomtom GPS
- 2010-08-31
- TOMTOM
- Tomtom GPS
- 2011-11-26
- Tomtom One XL Battery and chip change?
- Tomtom GPS
- 2011-11-25
