Bookmark this page:
If you were Registered and logged in, you could reply and use other advanced thread options
I have a BLM land ownership shapefile and when I add it as a layer,
ArcGIS Explorer covers the whole map in a single color instead of the
proper colors that show each section and its ownership status. What
am I doing wrong?
Thanks
ArcGIS Explorer covers the whole map in a single color instead of the
proper colors that show each section and its ownership status. What
am I doing wrong?
Thanks
Curious Joe wrote:
on the table of content, make a right click on your layer, then
"properties" and finally "symbology". You should have several options
for rendering your polygons.
Jean
on the table of content, make a right click on your layer, then
"properties" and finally "symbology". You should have several options
for rendering your polygons.
Jean
- Newly Signed Appropriations Measure Adds Layer of Political Protection for GPS
- Satellite Navigation
- 2011-12-29
- Land Based JPALS
- Satellite Navigation
- 2011-03-21
- Land Lot corner positions
- Satellite Navigation
- 2008-03-06
- Masking out land in Landsat image using either ILWIS or Grass
- Geographic Information Systems (GIS)
- 2008-05-11
- Where Exactly Is The Equator
- Satellite Navigation
- 2007-07-27
> ArcGIS Explorer covers the whole map in a single color instead of the
> proper colors that show each section and its ownership status. What
> am I doing wrong?
>
> Thanks